Applications Library

The robot arm loads the press with sometimes hot rawlings.
After the pressing procedure, the formed parts are removed from the press and palletized.

Application of a mechanical transfer system on a dual slide press for the production of automobile parts. Increasing the production performance by 50% to 12 strokes per minute in continuous mode operation at a travel in operating direction of 2700 mm. The overall length of the transfer unit is 17700 mm

Automation of a press tandem line consisting of 4 single presses for the manufacture of large surface automobile parts with a max. blank size of 4300mm x 2000mm. Direct transfer of parts from press to press with a distance of 7,2m without intermediate storage. Press line in permanent stroke mode (without stop at TDC) with up to 12 strokes per minute.

Automate the de-stacking, loading, unloading, and restacking of Frame Rails through bend, pierce, and form operations.
(4) Operators were manually running production on a 91 kg 5.3 meter frame rail. This part had to be run three times through a press to get the bend, pierce and form operation. Each batch had to be de-stacked, loaded/unloaded through a press and restacked or loaded into a rack.

Major automotive tier 1 supplier located in Melbourne/Australia was awarded to supply structural stampings and welded assemblies for Toyota in Australia. The parts for both of these tasks will processed and stamped by a 1500 Ton 6,100 x 2,400 transfer press.

Major HVAC (air conditioning) supplier located in Texas U.S.A. manufactures 4 different part sizes of air conditioner tops within a 1500 Ton 6100 x 2400 transfer press.